Hi I have a question regarding trying to level my Husqvarna Riding Mower Deck. It is a YTH22V46 model and I appear to have it level but I have some concerns.
Ok: So looking at the unit from behind, the high & low lever is on the left fender. Numbers range from 1 (lowest) to 6 (highest). I went to level the deck from directions and YOU TUBE from 6 (highest) setting. Now at that setting the blades above 4"+- I want to make the numbers on fender match the height of grass I want in my yard (if possible) so setting 1 - is 1" - 2 is 2" etc. The adjustment nut is on the left side only - so from reading, once you get it leveled side to side - it should be good to go. The adjustment nut up front on deck adjusts the front to back - and from reading you were suppose have front higher than back .
When I put the unit to 4 - the blades are 3" high - if I go to 3, they are in the 2 3/4 range - - any lower I butcher my yard. The plastic wheels on the deck I put down to the lowest hole (4 choices) so if I did drop the deck down it wouldn't gouge my yard. When i got the mower new they were in top holes I assumed was for transport only.
I guess I am asking is this ok - should I adjust it differently? Can someone tell me the right procedure? Do I adjust it in the 6 setting or drop it 3 and get that set at 3" and will be level ok? Should the plastic wheels be where i have them or should I change them - any help I would greatly appreciate.. Dave
Ok: So looking at the unit from behind, the high & low lever is on the left fender. Numbers range from 1 (lowest) to 6 (highest). I went to level the deck from directions and YOU TUBE from 6 (highest) setting. Now at that setting the blades above 4"+- I want to make the numbers on fender match the height of grass I want in my yard (if possible) so setting 1 - is 1" - 2 is 2" etc. The adjustment nut is on the left side only - so from reading, once you get it leveled side to side - it should be good to go. The adjustment nut up front on deck adjusts the front to back - and from reading you were suppose have front higher than back .
When I put the unit to 4 - the blades are 3" high - if I go to 3, they are in the 2 3/4 range - - any lower I butcher my yard. The plastic wheels on the deck I put down to the lowest hole (4 choices) so if I did drop the deck down it wouldn't gouge my yard. When i got the mower new they were in top holes I assumed was for transport only.
I guess I am asking is this ok - should I adjust it differently? Can someone tell me the right procedure? Do I adjust it in the 6 setting or drop it 3 and get that set at 3" and will be level ok? Should the plastic wheels be where i have them or should I change them - any help I would greatly appreciate.. Dave
Aucun commentaire:
Enregistrer un commentaire