8hp Briggs Driving me crazy

Hello



I'm looking for some help on my 8hp Briggs model 190432 type 0143-01 code 6909121.



Here is the story. I purchased the log splitter from a friend took it home put gas in it and pulled it a few times and it started up and ran great. It had been setting for about a year. I decided to pull the log splitter down and Restore it. I did not pull the engine apart just gave it a fresh paint job. Put it all back together and could not get it to start. So I checked to see if it had fire and no it did not. I pulled the cover off and found a mouse nest and the coil wire chewed up. I replaced it with part number 298968. Cleaned flywheel and air gapped to .010. Still no spark. Purchased a new set of point and installed them. I set gap to .020. Check for spark and I only get just a tingle at the end of the wire. I have tried two new coils and two new points sets. I have cleaned and set all air gaps many many times and it's the same. The flywheel magnet seem strong. I just don't know. This one has me stumped.