H70 Carb Removal?

Hi everyone. I have a snow blower with a Tecumseh H70 engine. I need to remove the carb to rebuild / clean it as the unit has been sitting for 5+ years. The issue i'm running into is the nuts hold the carb on are spinning on the bolts itself. Is there a trick at getting these off when this happens?



I tried removing the phillips head screws to take the entire unit off (kill switch/carb/mount) but one of the screws is badly stripped.





Any help would be appreciated! Thanks!



Mike

Attached Images

• 20141012_175005[1].jpg (143.4 KB)