Hi all,
I may be crazy, but today I tried to change the oil for first time on MZT52 and I can't figure out how to remove the drain cap! (I'm at 12 hours run time doh...adds up fast...book says change at 8. Hopefully extra four hours won't hurt anything). So the mower has the little hose thing that hangs off the end. There are two points on this that look like hex points for 11/16" wrench (that fit them anyway). From what it looked like, the one farther back is the cap and should twist off. Well I torqued the hell out of it and nothing happened. It acts like one piece. Is this the right way to remove the cap?
Here is how it looks:
and here is how I was trying to remove it:
Is this the right way? Maybe it's just super tight from factory. I was scared to hulk mode it as it looks like one piece. Can somebody post a pic with cap removed so I can see how it looks?
Sorry I am still learning this!
I may be crazy, but today I tried to change the oil for first time on MZT52 and I can't figure out how to remove the drain cap! (I'm at 12 hours run time doh...adds up fast...book says change at 8. Hopefully extra four hours won't hurt anything). So the mower has the little hose thing that hangs off the end. There are two points on this that look like hex points for 11/16" wrench (that fit them anyway). From what it looked like, the one farther back is the cap and should twist off. Well I torqued the hell out of it and nothing happened. It acts like one piece. Is this the right way to remove the cap?
Here is how it looks:
and here is how I was trying to remove it:
Is this the right way? Maybe it's just super tight from factory. I was scared to hulk mode it as it looks like one piece. Can somebody post a pic with cap removed so I can see how it looks?
Sorry I am still learning this!
Aucun commentaire:
Enregistrer un commentaire